You can test a rollover cable with DTX Version 1.4 or later (Current Version is 2,78), BUT you will have to create a custom test limit first. The following steps will walk you through on how to set up your DTX CableAnalyzer to do this.
-
Turn the dial to SETUP
-
Select Twisted Pair, Press ENTER
-
Select Test Limit, Press ENTER
-
Press F1 for More
-
On the Test Limit screen, scroll down to Custom, Press ENTER
-
Once in the Test Limit Custom screen Press F1 Create
-
Press ENTER on Name and give the Test Limit a name, then Press SAVE
-
Select Use Default Values and press ENTER
-
From here you can select the test standard you desire to use the default values from.
-
Select the Test Standard and press SAVE
-
You will need to select the test after it has been created, this is done when by pressing ENTER on your newly created custom test name. (CAUTION: Most people forget to do this step)
-
Select Outlet Configuration and press ENTER.
-
Select Rollover, then press ENTER.
-
Rotate the dial back to AUTOTEST to begin testing.
|
