When was the last time my OMNIScanner was factory calibrated? | Fluke Networks


KB-Startseite   >  Kupfertest   >  OMNIScanner™

When was the last time my OMNIScanner was factory calibrated?

The last OMNIScanner left the factory back in July 2005. We regret to say service and support ended July 2009. It's replaced by the Versiv familly of testers.
There is a calibration date code on the OMNIScanner and the OMNIRemote.
To view these do the following: 
Press and hold the backlight button (located just above the ESC Key).
The contrast screen will come up and the date code is listed at the bottom.
OMNIScanner Contrast Screen 

From the Main screen on the OMNIScanner, go to the Setup.
Press the arrow at the bottom of the screen to go to the second Setup screen.
Select Remote Info.
OMNIRemote Info Screen 

There are 2 different kinds of codes that have been used by Microtest. The one shown on the OMNIScanner section is the current one being used. It is interpreted as follows:
A2 is the Calibration fixture used
01 is the year calibrated
05 is the month calibrated
31 is the day calibrated 

The older format is interpreted as follows:
1999 is the year calibrated
09 is the month calibrated
25 is the day calibrated

Verfasser: Fluke Networks

Erstellungsdatum: 27. Februar 2014

Letzte Änderung: 27. Februar 2014

Powered By OneLink