Internal memory - OMNIScanner | Fluke Networks


KB-Startseite   >  Kupfertest   >  OMNIScanner™

Internal memory - OMNIScanner

The last OMNIScanner left the factory back in July 2005. We regret to say service and support ended July 2009. It's replaced by the Versiv familly of testers.
The OMNIScanner has a limited amount of memory. The OMNIScanner can typically hold up to 1000 Autotest results. However, if the user enables saving Graphs, this storage is reduced. The reason is that the OMNIScanner stores the full sweep data for each test and each wire pair to be able to recreate the Graphs on any printouts.
Graphs can be enabled or disabled from the Setup Menu and the Save Autotest Options. Select the Setup Key and then highlight Autotest Save Options and press Enter.

In the Save Options screen above shows all the Graphs disabled. They can be enabled individually to save only the ones the user wants. Highlight the Graph option and the press the Select Key . This can be done for each Graph.
The OMNIScanner can store the following amount of Autotests in internal memory with all Graphs enabled:


With Graphs

        Without Graphs

Category 6



Category 5e



Category 5



Verfasser: Fluke Networks

Erstellungsdatum: 27. Februar 2014

Letzte Änderung: 27. Februar 2014

Powered By OneLink